Filter
Top Products
13
24. Remove the preattached 3 1/2” Pulleys (78) from
the Offset Double “U”-bracket (61).
Wrap the Swivel Cable (17) around a 3 1/2” Pulley
(78). Attach the Pulley to the Offset Double “U”-
bracket (61) with a 3/8” x 1 3/4” Bolt (93) and a 3/8”
Nylon Locknut (87).
25. Wrap the Swivel Cable (17) around a 3 1/2” Pulley
(78). Attach the Pulley and a Cable Trap (68) to the
next to bottom hole in the Small Pulley Plates (31)
with a 3/8” x 2” Bolt (100) and a 3/8” Nylon Locknut
(87). Make sure the Cable Trap is turned to hold
the Cable in the groove of the Pulley.
26. Wrap the Swivel Cable (17) around a 3 1/2” Pulley
(78). Attach the Pulley and a Cable Trap (68) to the
bracket on the Swivel Upright (5) with a 3/8” x 2”
Bolt (100) and a 3/8” Nylon Locknut (87). Make
sure the Cable Trap is turned to hold the Cable
in the groove of the Pulley.
27. Attach the end of the Swivel Cable (17) to the
bracket on the Swivel Carriage (46) with a 3/8” x 1”
Bolt (13) and a 3/8” Nylon Locknut (87).
28. Locate the Lat Cable (88), which is 89 1/4” long
and has a ball on one end and an eyelet on the
other. Route the eyelet end of the Cable up through
the Butterfly Top Frame (7) and around a 3 1/2”
Pulley (78). Attach the Pulley inside of the Butterfly
Top Frame with a 3/8” x 2 3/4” Bolt (101), two 3/8”
Washers (91), two 1/2” Spacers (89), and a 3/8”
Nylon Locknut (87).
28
24
25
26
27
78
87
93
17
61
100
78
17
78
68
46
87
17
13
17
87
68
101
87
88
91
91
89
89
7
78
31
87
100
5