Filter
Top Products
5
1. Before beginning assembly, be sure that you
have read and understand the information in
the box above.
Attach the Left Base (53), the Right Base (40),
and the Lat Base (48) with two M8 x 60mm
Carriage Bolts (3), two M8 x 68mm Bolts (1), and
four M8 Nylon Locknuts (11). Do not tighten the
Nylon Locknuts yet.
2. Press a 50mm Square Inner Cap (21) into each
Weight Upright (42). Press four 25mm Round
Inner Caps (23) into each Weight Upright.
Attach a Weight Upright (42) to the Left Base (53)
with an M8 x 60mm Carriage Bolt (3) and an M8
Nylon Locknut (11). Do not tighten the Nylon
Locknut yet.
Attach the other Weight Upright (42) to the Right
Base (40) with an M8 x 60mm Carriage Bolt (3)
and an M8 Nylon Locknut (11). Do not tighten
the Nylon Locknut yet.
1
1
11
40
53
3
23
23
21
21
42
42
40
53
11
3
11
3
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Read each assembly step before you begin.
• For help identifying the small parts used in
assembly, use the PART IDENTIFICATION
CHART at the center of this manual. Note: Some
small parts may have been pre-attached for ship-
ping purposes. If a part is not in the parts bag,
check to see if it has been pre-attached.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• During assembly, make sure that all parts are ori-
ented as shown in the drawings.
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
REQUIRED FOR ASSEMBLY:
• Two (2) adjustable wrenches
• One (1) standard screwdriver
• One (1) rubber mallet
• Lubricant, such as grease or petroleum jelly,
and soapy water will also be needed.
Assembly will be more convenient if you have the
following tools: A socket set, a set of open-end or
closed-end wrenches, or a set of ratchet wrenches.
2
48