Vision Fitness ST720 Home Gym User Manual


 
11
1
STEP
• Slide the sliding seat bottom assembly
(AH1) onto the sliding seat support tube
(AH2), rollers first. Disengage pull pin of
seat bottom assembly until it locks into one
of the range of motion holes in the support
tube.
• Set main floor support (AC1) on the
ground, with curved end up, and place
sliding seat support tube so that holes in
the end of the floor support line up with the
holes on the sliding seat support tube.
Attach using two bolts (M10x70), four flat
washers (10.2x22x2), and two nylon nuts
(M10).
• Place the seat back support post (AT3)
over the opposite end of the sliding seat
support tube (AH2), aligning the holes in
all three frame sections. Thread two bolts
(M10x20) and two flat washers
(10.2x22x2) through top of seat back
support post. Do not place any bolts
through other holes, as it will be done in
the following step!
ORANGE BAG