Tunturi E25 Elliptical Trainer User Manual


 
GB
O W N ER ’ S M AN U AL
E 2 5
9
contact your Tunturi dealer immediately. Always give
the model and serial number of your equipment. Please
state also the nature of the problem, conditions of use
and purchase date.
If you require spare parts, always give the model, serial
number of your equipment and the spare part number
for the part you need. The spare part list is at the back
of this manual. Use only spare parts mentioned in the
spare part list.
TRANSpORT AND STORAGE
Please follow these instructions when carrying and
moving the cycle about, because lifting it incorrectly
may strain your back or risk other accidents:
NOTE! Always switch the power off and unplug the
power cord before you start moving the equipment
around!
Stand behind the equipment. Grip the seat with one
hand and the handlebar with the other, and set your
foot on the rear support. Tilt the equipment so that
it rests on its transport wheels. Wheel the equipment
to move it, on these transport wheels. Lower the
equipment while holding on to the handlebar and
remain behind the equipment all the time. NOTE!
Transport the equipment with caution over uneven
surfaces, for example over a step. The equipment should
never be transported upstairs using the wheels over
the steps, instead it must be carried. We recommend
that you use a protective base when transporting the
equipment.
To prevent the equipment malfunctioning, store in a dry
place with as little temperature variation as possible and
protected from dust.
TECHNICAL SpECIFICATIONS
Length .................................................97 cm
Width ...................................................70 cm
Height ..................................................129 cm
Weight .................................................42 kg
This product meets the requirements of the EU’s EMC
Directives on electromagnetic compatibility (89/336/
EEC) and electrical equipment designed for use within
certain voltage limits (73/23/EEC). This product
therefore carries the CE label.
This product meets EN precision and safety standards
(Class HA, EN-957, parts 1 and 5).
Due to our continuous policy of product development,
Tunturi reserves the right to change specifications
without notice.
NOTE! The instructions must be followed carefully in
the assembly, use and maintenance of your equipment.
The warranty does not cover damage due to negligence
of the assembly, adjustment and maintenance
instructions described herein. Changes or modifications
not expressly approved by Tunturi Oy Ltd will void the
user’s authority to operate the equipment!
We wish you many enjoyable trainings with your
new Tunturi training partner!