Filter
Top Products
TOPCOM TWINTALKER 3000 11
TOPCOM TWINTALKER 3000
11
TOPCOM HB 4F00 11
ENGLISH
11.4 HEART RATE MEASUREMENT
In time mode:
• S4: To go to Heart rate mode.
• S3: To activate the heart rate measurement
• When hartrate is recieved from the belt the fol-
lowing will be showed:
- the heart rate in beats per minutes
- Percentage of estimated maximum heart rate
%EMHR ( = current HR/MHR*100%)
11.5 HEART RATE WITH EXERCISE TIMER
During heart rate measurement press S2 to toggle between current HR
measurement and excercise time. The excercise time automatically starts
when valid HR is measured.
When no HR is measured during 10 seconds, the timer will stop and flash.
If no HR is measured during 50 seconds, the HR measurement will stop and
turn off automatically.
When the HR measurement is started again after it has been stopped, the
timer will start again from the last reading.
To reset the timer make sure it’s stopped: Press [S4] to reset
The watch will beep every 10 seconds if no heart rate signal is
received from the belt. After 1 minute if no heart rate is received
the watch will return to Idle mode.
percentage of estimated
acquired heart rate
(beats per minute)
maximum heart rate
Heart Rate Alert ON Exercise Timer Counting
HB 4F00.book Page 11 Monday, March 17, 2008 5:01 PM