Page 18
INSTALL SAFETY STOPS:
1. Take the (2) Safety Stops (PN:731-2337) from the packaging.
2. Install the Safety Stops onto the machine at this time, make sure they are both at the same level.
3. Take the Bar with the Bearing guides and place it on the safety stop as in the image.
INSTALL BEARING MOUNTS TO BAR:
1. Take the (2) Ø30mm Guide rods with threaded hole in one end (PN:731-2393) from the packaging.
2. Using (2) m10 x 25 Hex Head Bolts (PN:731-2333), and (2) m10 Large Washers (PN:731-2396),
install the rods through the bar bearing guides with the threaded holes up and the bearing tube to the
back of the machine, then push the rod up into the upper bearing weldment. NOTE: DO NOT force
the rod into the bearing this may damage the bearings.
3. Use a 17mm box wrench to tighten the bolts.