Filter
Top Products
Page 15
INSTALL WEIGHT HOLDERS:
1. Take the (2) weight holder weldments (PN:731-2355-XX) from the packaging.
2. Using (2) mounting plate (PN:731-23), (4) m10 x 140 Hex Head Bolts (PN:731-2398), (8) m10
Washers (PN:731-2419), and (4) m10 Nyloc Nuts (PN:731-2420), install the weldment to the back of
the Main Assembly. Before tightening Fasteners place (2) boots (PN:731-0021) under the feet of the
weldments. Use (2) 17mm box wrenches to lightly tighten these fasteners at this time.
NOTE: Make
sure you use the right length of bolt.
INSTALL LOWER BRACES:
1. Take the (2) cross brace weldments (PN:731-2317-XX) from the packaging.
2. Using (2) brackets (PN:731-2315-XX), (8) m10 x 140 Hex Head Bolts (PN:731-2398), (16) m10
Washers (PN:731-2419), and (8) m10 Nyloc Nuts (PN:731-2420) install the weldments between the
legs of the Main Assembly. Adjust all six feet to firm to the ground. Use (2) 17mm box wrenches
tighten all fasteners at this time even upper cross members.
NOTE: Make sure you use the right
length of bolt.