Filter
Top Products
Page 12
UNPACK THE MAX RACK and ASSEMBLE UPPER WELDMENTS:
NOTE: TAKE CARE WHILE OPENING THE BOXES. KEEP TRACK OF ALL ITEMS YOU REMOVE FROM
THE BOXES. TAKE CARE NOT TO LAY ITEMS ON SURFACES THAT MAY SCRATCH THE
PRODUCT.
1. Take the front and back upper weldments and place them on a soft surface. (A moving blanket will
help reduce damage from hard surfaces)
2. Take (2) of the cross weldment and lay them between the upper weldments.
3. Take (4) bracket and lay (2) at each end as shown below.
4. You will need (8) m10 x 140mm Hex Head bolts (PN:731-2398), (8) m10 Nyloc nuts (PN:731-2420),
and (16) m10 washers (PN:731-2419). NOTE: Make sure you use the right length of bolt.
5. Using (2) 17MM box wrenches assemble the components as seen below. Snug the fasteners at this
time.