Star Trac E-ST Stepper Machine User Manual


 
This section provides regulatory and safety information pertaining to the STAR TRAC E-ST STEPPER.
FCC AND OTHER DOMESTIC REGULATIONS
The Stepper has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC rules. Under
FCC guidelines, operation is subject to the following two guidelines: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
The Stepper generates and uses radio frequency energy. If the product is not installed and used in accordance with the instructions pro-
vided in the owner’s manual, interference with radio communications may occur. Likewise, if unapproved accessories are installed, inter-
ference with radio communications may occur. The intent of the FCC class A limit is to provide reasonable protection against harmful
interference in a commercial installation. However, there is no guarantee that interference may not occur in a specific installation. In the
event that interference is experienced, turn off the unit to verify that it is the source. If the interference clears with the unit off, then try
each of the following measures and combinations thereof:
Reorient or relocate the Stepper.
Reorient or relocate the receiving antenna for your television, radio or VCR.
If using the wall outlet option, connect the unit to a different power outlet.
Contact Star Trac Product Support, your authorized dealer, or a qualified radio/television technician for help.
This product has also been tested to meet the following standards:
UL 1647 (1997) Motor Operated Massage and Exercise Machines
CANADIAN DOC AND OTHER REGULATIONS
This class A digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regulations.
This product has also been tested to meet the following standards:
CSA C22.2 No 0-M91 General Requirements
CSA C22.2 No. 68-92 Motor Operated Appliances
EUROPEAN APPLICATIONS
This product has been tested to the following standards:
EN 60335-1:1995 Safety of household and similar electrical applicances Part 1: General requirements
EN 61000-6-1:2001 EMC Generic standards - Immunity for residential, commercial and light-industrial environments
EN 61000-6-3:2001 EMC Generic standards - Emissions standard for residential, commercial and light-industrial environments
EN 957-1 Safety of Machinery
STAR TRAC E-ST STEPPER OWNERS MANUAL 29
STAR TRAC E-ST STEPPERS perform a self-test at the beginning of every workout. If a problem is detected, a message displays before
or after the workout, depending on the nature of the problem. Star Trac recommends that you refer your questions about your STAR
TRAC E-ST STEPPER operation and suspected malfunctions to Star Trac’s Service Hotline at (800) 503-1221, or USA 1-714-669-1660.
SERVICE MESSAGES
The following messages are displayed if the associated problem is detected during self-test.
Key Down - One or more keys on the display panel are stuck in the “on” position. This can occur if a user presses keys before
the system is turned on, or if a key is held down for more than 10 seconds. Call Star Trac Product Support for assistance if the
Key Down message continues to display.
TROUBLESHOOTING
REGULATORY INFORMATION