Star Trac E-RBi Elliptical Trainer User Manual


 
7. Press the to exit.
This completes the E-TR setup, now turn to the “Accessing The On Screen Display” to continue.
For “Maintenance Mode” on the E-TBT, E-ST, E-RB, and E-UB follow the steps
below.
1. Press and hold the
,
and keys together.
2. A beep will sound and “MAINTENANCE SETTINGS” will display momentarily in the Information
Window.
3. Release all keys. “SERIAL NUMBER” will display in the Information Window.
The following keys are available in MAINTENANCE SETTINGS:
Upper and Lower Data Information Window S
CROLL Keys: Display the next and pre-
vious parameters, respectively. Keys will repeat if held.
Increase and Decrease L
EVEL Keys: Adjust the value of the displayed parameter up
and down, respectively, in increments of 1 unit . These keys do not save the new value
- see OK Key below.
OK Key: Updates (saves) the value of the displayed parameter in Flash memory, and
exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the Q
UICK START key.
The items that you may display and change with the previous keys are:
4. Press either to navigate to the “PVS” variable.
5. Press the (level up) to change the variable from ATCS/NTSC to PAL/SECAM.
6. Press the to save the change and exit.
This completes the E-TBT, E-ST, E-RB, and E-UB setup, now turn to “Accessing The On Screen
Display” to continue.
STAR TRAC P
ERSONAL
V
IEWING
S
CREEN
O
WNER
S
G
UIDE
31