Filter
Top Products
ASSEMBLY INSTRUCTIONS
Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at :
parts@staminaproducts.com
5
STEP 1
Remove your PILATES PREMIER from its packaging placing the product on its side, with the LOCKING
PIN(26) side upward. Remove the LOCKING PIN(26) and unfold the MAIN FRAME ASSEMBLY to a
flat position by moving the
FRONT FRAME(1) away from the platform end of the product in a clockwise
position until fully extended.
STEP 2
Remove the paper covering from the foam tape inside the FRONT END COVER(6) and REAR END
COVER(7). Place the FRONT END COVER(6) over the FRONT FRAME(1). Press the FRONT END
COVER(6) securely in place. Place the REAR END COVER(7) over the REAR FRAME(2). Press the
REAR END COVER(7) securely in place.
NOTE:
The securing
SCREWS(M6 x 35mm)(37) for the PULLEY ASSEMBLY(22) on each side may
need to be loosened to allow the
REAR END COVER(7) to fit securely over the frame. Refer to
illustration. When retightening the screws for the
PULLEY ASSEMBLY(22) do not over tighten.
The
PULLEY ASSEMBLY(22) should move freely.