Filter
Top Products
10
SET UP INSTRUCTIONS
Place the Magnetic Recumbent 4825 Bike in the area where it will be used. It is recommended that the
Magnetic Recumbent 4825 Bike be placed on an equipment mat. The Magnetic Recumbent 4825 Bike
is approximately 58 inches long (max.) x 26 3/4 inches wide x 31 3/4 inches tall. (These dimensions may
vary up to one inch.) An area 4 feet wide x 7 feet long is required for safe operation of the Magnetic
Recumbent 4825 Bike. Make sure that adequate space is available for access to and passage around the
Magnetic Recumbent 4825 Bike.
EQUIPMENT MAT
Please note the Rear Frame of the
Recumbent Bike is adjustable. Use the
longest size to determine the size of the mat.
Adjust the LEVELING CAPS(50) on the REAR STABILIZER(4) so that the Recumbent Bike
sits on the floor without rocking.
The Magnetic Recumbent 4825 Bike has a pair of WHEELS(49) on the FRONT STABILIZER
(2). Lift up from REAR STABILIZER(4) to move the Magnetic Recumbent 4825 Bike.
LEVELING:
MOVING:
FUNCTION INSPECTION:
Visually inspect the Magnetic Recumbent 4825 Bike to verify that assembly is as shown in the above
illustration. Check the function of the Magnetic Recumbent 4825 Bike by turning the crank slowly through
one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(25) and
verify that it functions properly.
Locate and read the WARNING LABEL(78) on the Magnetic Recumbent 4825 Bike. Make
sure that all users read the WARNING LABEL(78).
CAUTION: