Filter
Top Products
14 15
ShrinQ
REPLACING THE BATTERY CARE & MAINTENANCE
• NEVER get the pedometer wet. This unit is not water resistant.
•
DO NOT expose the unit to extreme heat, shocks, magnetic fields, electrical noise, strong
vibration or long-term exposure to direct sunlight.
•
DO NOT drop or step on the pedometer.
•
TO CLEAN THE UNIT: wipe with a lightly moistened cloth. Apply mild soap to the area if
there are stubborn stains or marks. Do not expose the unit to strong chemicals such as
gasoline, cleaning solvents, acetone, alcohol, insect repellents, as they may damage the
unit’s seal, case and/or finish.
•
STORE the unit in a dry place when you are not using it.
CUSTOMER SUPPORT
If you have questions, comments or need assistance with your Sportline ShrinQ, you may
contact Customer Support by calling
1-800-338-6337.
The Sportline ShrinQ Pedometer uses one CR2032 3V lithium battery.
Battery replacement will be required from time to time, and should occur when:
1. The display fades in part or completely
2. The pedometer function will not activate
Replacing the battery:
1. Unscrew the battery compartment cover on the backside of the unit using a small Phillips
screwdriver and remove the cover.
2. Remove the exhausted battery from the unit, and insert a new battery (be sure to place
the positive (+) side of the battery is visible, facing toward the battery compartment
cover).
3. Replace the battery compartment cover on the battery compartment and fasten the screw
(CAUTION: do not over tighten).
CAUTION – BATTERY SAFETY INFORMATION
• Non-rechargeable batteries are not to be recharged
• Rechargeable batteries must be removed before recharging
• Rechargeable batteries only to be recharged under adult
supervision
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel-cadmium) batteries
• Exhausted batteries to be removed
• Do not mix old and new batteries
• Do not dispose of battery in fire; battery may explode or leak
• Do not dispose of product in fire; battery may explode or leak
• If this product will not be used for an extended period of
time, remove the batteries from the product
• The supply terminals are not to be short-circuited
• Batteries are to be inserted with correct polarity
• Clean the battery contacts and also those of the product
prior to battery installation
• As always, dispose of batteries in an eco-friendly manner
WV4407IS01SPTRA.indd Sec2:14-Sec2:15WV4407IS01SPTRA.indd Sec2:14-Sec2:15 4/16/14 2:32 PM4/16/14 2:32 PM