Spirit Z9 Treadmill User Manual


 
Z9
6
familiar with its function and limitations. The treadmill will stop, depending on speed,
with a one to two step coast anytime the magnet is pulled off the console. Use the red
Stop / Pause switch in normal operation.
ASSEMBLY PACK CHECK LIST
5/16"x 1/2" Button Head Socket Screw (14pcs)
5/16” x 18 x 1.5T Flat Washer (6pcs)
5/16” x 23 x 1.5T Curve Washer (2pcs)
Safety Key (1pc)
Lubricant (1pc)
M5 Allen Wrench (1pc)
M6 Allen Wrench (1pc)
Assembly
STEP 1
Remove all parts from the carton.
STEP 2
Connect Computer Cable (middle) with Computer cable (lower).
STEP 3
Hand tighten the Left and Right Handrails into the Base with 8 pcs of 5/16” x 1/2”
Button Head Socket Screws, 6 pcs of 5/16” x 18 x 1.5T Flat Washers and 2pcs of
5/16”x 23x1.5T Curve Washers by using the M5 Allen Wrench.
STEP 4
Connect Speed Adjustment Switch w/Cable with Speed Cable (middle).
And connect Incline Adjustment Switch w/Cable with Incline Cable (middle).
STEP 5
Hand tighten the Left and Right Handrails with 4 pcs of 5/16” x 1/2” Button Head
Socket Screws by using the M5 Allen Wrench.
STEP 6
Connect 12 pin 1300 mm Computer Cable (middle) with 12 pin 800 mm Computer
cable (upper).
Connect Speed Cable (middle) with Speed Cable (upper) and Incline Cable (middle)
Assembly Instructions (Z9)