Filter
Top Products
XT485 Treadmill
16
The 1/4-mile track (one lap) will be displayed around the dot matrix window. The
ashing segment indicates your progress. Once the 1/4-mile (Metric - 0.4k) is
complete this feature will begin again. There is a lap counter in the message
window for monitoring your distance.
1/4 MILE TRACK
The Pulse (Heart Rate) console window will display your current heart rate in beats
per minute during the workout. You must use both stainless steel sensors on the
front cross bar or the heart rate transmitter chest strap to display your pulse. Pulse
value displays anytime the upper display is receiving a Pulse signal. You may not use
the Grip Pulse feature while in Heart Rate Programs.
Note: Refer to Important Safety Instructions (page 2) concerning Pulse Grip operation.
PULSE GRIP FEATURE
Displays the cumulative calories burned at any given time during your workout.
Note: This is only a rough guide used for comparison of different exercise sessions,
which cannot be used for medical purposes.
CALORIE DISPLAY
The console has built-in Speakers. You may plug an Audio Source (CD player, MP3,
Computer, etc.) into the Jack on the right side of console. There is no volume control
on the console. The volume must be controlled on the Audio Source.
SPEAKERS
To the right of the Stop button there is a Handrail control switch and an indicator
light next to it When the indicator light is lit, the handrail switches are disabled. This
allows you to use the full length of the handrails without fear of activating the speed
or elevation controls.
HANDRAIL BUTTONS DISABLE SWITCH
1. Display will automatically turn off (go to sleep) after 30 minutes (no key
operations). The treadmill will draw very little current in sleep mode (about as
much as your television when it is turned off).
2. Remove the tether cord.
3. Turn off the main switch on the front of the treadmill, below the motor cover.
TO TURN TREADMILL OFF