Filter
Top Products
8
Elliptical T
rainer
XE395
1. Place two Wave Washers (103) onto the left and right Console Mast shafts; Slide the left (10) and right (11)
swing arms onto the shafts and secure with two Hex Head Bolts (74) and two Flat Washers (99); tighten with
the wrench (129). Note: make sure the arms are placed on their respective shafts as shown in the illustration.
2. Slide a grommet (145) onto the left cable (146-1); connect that cable to the cable (147) of the left swing arm
(10); snap the grommet into the hole on the side of the console mast tube, then push the excess amount of
cable through the grommet. Repeat this process on the right side,
connecting cables (146 & 147).
3. Match the Front Handle Bar Cover (L) (68) with Rear Handle Bar Cover (L) (68-1) on left Swing Arm (10)
and secure with three Sheet Metal Screws (107). Tighten using the Phillips Head Screw Driver (126). Repeat
for the right Swing Arm (11), matching covers (69 & 69-1).
HARDWARE
STEP 2: Swing Arms
#103. 17mm
Wave Washer
(4 pcs)
#99. 5/6” x 23 x 1.5T
Flat Washer
(2 pcs)
#107. 3.5 x 12mm
Sheet Metal Screw
(6 pcs)
#74. 5/6” x 15mm
Hex Head Bolt
(2 pcs)
#145. Grommet
(2 pcs)