Filter
Top Products
11
right. Repeat the process
until all four digits are
entered as your tire cir-
cumference. Press the
“SET” button once to select
it and enter the circumfer-
ence for wheel option #2.
Follow the same procedure
to program the wheel #2
tire size and tap the “SET”
button to exit circumfer-
ence programming mode.
5. Setting the Clock
Your Turbo® Comp fea-
tures a digital clock. To
access the “clock mode”
press and the “MODE”
button repeatedly until
CLOCK appears in the
Dot-matrix Display Area.
To set the clock, press the
“SET” button for three sec-
onds. The display will flash
either twelve (12:) or twen-
ty four (24:). Select
between 12: or 24: mode
by pressing the “MODE”
button. Press the “SET”
button to confirm your
selection. The hour digit
will now begin flashing.
Press the “MODE” button
to adjust the hour digits.
AM/PM is selected by
scrolling the hour digit.
Press the “SET” button to
accept the hour selection.
The minutes will flash and
can be adjusted by press-
ing the “MODE” button.
(Hold the “MODE” button
to scroll through the digits
quickly) Press the “SET”
button to set the minutes
and return to clock mode.
6. Timer Selection
The Turbo® Comp has two
timers; Automatic Timer
Mode (ATM) and Timer
Mode (TIMER). The ATM
selection allows you to
keep track of your actual
riding time. The ATM timer
only operates when the
wheel is rotating and can-
10
Odometer (ODO) mode
and then hold down the
“MODE” button for three
seconds. The display will
now show the currently
selected tire size for wheel
option #1. (See figure
13). If necessary scroll
through the prepro-
grammed tire sizes by
tapping the “MODE” but-
ton until the display shows
MM and four-digit num-
ber. This number repre-
sents your tire circumfer-
ence in millimeters. Press
the “MODE” button until
the flashing digit is cor-
rect. (Note: The “MODE”
button may be held to
scroll to the correct digit.)
Press the “SET” button to
select the next digit to the
not be turned on or off
manually.
Note: The average speed
(AVSPD) calculation is
based upon the ATM time.
The TIMER function is just
like a conventional stop-
watch. The timer is activated
manually and records the
time whether the wheel is
rotating or not. Tapping the
“TOP” button starts and
stops the stopwatch and
when the timer is stopped,
holding the “SET” button for
three seconds will reset to
stopwatch. The TIMER
includes a 12-memory lap
time feature. To record a lap
time, press the “SET” button
once while the stopwatch is
running. Each time the
“SET” button is depressed
the Turbo® Comp will
record the lap time. After
the TIMER has been stopped
(by pressing the “TOP” but-
ton) the previous twelve lap
times can be reviewed by
pressing “SET” button.
Additionally, the computer
will display the total time
when LPTOT is shown.
FIGURE 13
FIGURE 14