Filter
Top Products
16
“OPERATION INSTRUCTIONS”
HOW TO CHANGE THE WLLIPTICAL BIKE MOTION
STEP MODE:
The item can be used in the ELLIPTICAL mode or the STEP mode.
Refer to the following process to set up the ELLIPTICAL mode or the STEP mode.
a. Before exchanging the ELLIPTICAL mode with the STEP mode
, make sure the SIDE YOU ARE ADJUSTING IS IN
the lowest position as the figure shows below
b. Remove the Locking Knob (68) from the Right Pivoting Arm (13)
c. Attach the Right Pedal Linkage (19) to the Rear Stabilizer (8) and fully tighten the Locking Knob (68)
d. Repeat the above process on the left side
CAUTION: Make sure both Locking Knobs (68) are tightened before exercising
ELLIPTICAL MODE: