Filter
Top Products
Page 21
TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant
belt adjustment may be necessary.
The treadmill is designed to keep the treadbelt reasonably centered while in use. It is
normal for some belts to vary near a side while the belt is running with no one on it. After a
few minutes of use, the treadbelt should have a tendency to center itself. If, during use, the
belt continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 1/4” allen wrench is provided to adjust the rear roller. Make tracking adjustments from the
left side only. Set belt speed at approximately 2 to 3 mph. A small adjustment can make a
dramatic difference. Turn the bolt only a 1/4 turn and wait a few minutes for the belt to
adjust itself. Continue to make 1/4 turns until the belt stabilizes in the center of the running
deck.
The belt may require periodic tracking adjustment depending on use and walking/running
characteristics. Some users will affect tracking differently. Expect to make adjustments as
required to center the treadbelt. Adjustments will become less of a maintenance concern
as the belt is used. Proper belt tracking is an owner responsibility common with all tread-
mills.
CAUTION - KEEP HANDS CLEAR OF MOVING REAR PULLEY!
Belt will move in direction of allen wrench.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE SMOOTH WARRANTY.
LUBRICATION:
Do not relube with other than Smooth lubricant. See your Smooth dealer for purchase. The
use of some other lubricants may destroy the deck surface or belt and will void warranty. If
the treadmill belt/deck is kept reasonably clean it should be lubricated every 6 months or
every 1000 hours of use.