Filter
Top Products
Page 10
Operating Features
Pause Feature:
Workouts may be paused at any time, during either manual or program operation. During a
pause, Time and Distance will be held. Speed and Incline may be adjusted while paused.
1. Press [STOP/PAUSE]. The treadbelt slowly decelerates to zero mph.
2. Press [START BELT] to resume workout at previous settings.
Pace Feature:
Your pace is the amount of time that it will take to walk or jog a mile. When selected, your
pace in minutes and seconds will display in left hand window and adjust up or down as
speed is changed.
1. While treadbelt is moving, press [SELECT] until the word PACE appears in the left
hand window. In a few seconds, your pace is computed and displayed in the left
hand window.
Incline Feature:
The Incline may be adjusted anytime the display is lit. A small “dot” (light) will flash as
incline motor is raising / lowering treadmill. This is a diagnostic device indicating the upper
display is receiving an input signal from lower electronics.
1. Press and hold the [INCLINE +/-] the keys to achieve desired level of effort.
Panel Dim Feature:
The Panel Dim feature is available when the belt is moving and will blank out the display.
After belt movement, pressing [PANEL DIM] will blank out the display. Pressing any other
key while dimmed will “wake” the display back up for a few seconds.
1. Press [PANEL DIM] to blank out the display. Press again to cancel.
Track Feature:
The center display window can display your progress on a simulated 1/4 mile track, using a
blinking dot on the track to show your location. The left hand window will display the num-
ber of laps.
1. Before belt movement, press [SELECT] until a large oval is displayed in the center
window.
2. Press [START BELT] to begin.