Filter
Top Products
24 6.75 TREADMILL
TROUBLESHOOTING
Troubleshooting with Error Codes
Electronics continuously run a self-check. If it finds an irregularity, the electronic console will display an
error code and stop normal operations for safety.
Error Code Description E1 Speed Error
E6/E7 Incline Error
Error
Code
Troubleshooting
E1:
When E1 is displayed, remove safety key and insert it again to restart treadmill. If E1
is still shown on display, please check the following:
1. Please check all cable connections are well connected.
2. The treadmill did not move after pressing “Start” and shows E1, please check if t
here is any part stuck.
3. The treadmill runs for a few seconds after pressing “Start” but stops, please check if
the sensor (near flywheel of front roller) is loose or defective.
4. Please check if wires connected to motor are loose or not.
5. Please contact stores for service if E1 cannot be resolved.
E4:
Under Body Mass Program, heart rate is not read during continuous 8 sec.
1. Please reset or remove safety key. Then run body mass program again.
E6/E7:
When E6/E7 is displayed, remove safety key and insert it again to restart treadmill. If
E6/E7 is still shown on display, please check the following or call for service.
1. Reset incline value.
(1) When the position of incline is lower than middle level, press “MODE” and
“Incline up” buttons. Hold both buttons and the incline will be raised. Release the
two buttons until the incline position is up to the middle level.
(2) When the position of incline is higher than middle level, press “MODE” and
“Incline down” buttons. Hold both buttons and the incline will be reduced. Release
the two buttons until the incline position is down to middle level.
Please try it a few times. If you cannot get the incline moved, please contact stores for
service.
Once the incline position is at middle level, please turn off power and restart. Please
see if E6/E7 goes away. If not, please contact stores for service.
2. Please check if red/white incline cables are well-connected to MCB.
3. If the above steps cannot reset incline, please contact stores for service.