Filter
Top Products
15
English
14
English
MEMORY RECALL MODE (RCLL)
A
Press to show the MEMORY RECALL mode.
4 Split time measurement
* Timing and release of split times can be repeated as many times as required by
pressing Button D.
* The split time measured remain displayed for 10 seconds together with the flashing
split indicator, and then the display automatically returns to the measurement in
progress.
* When Button C is pressed at the end of timing, the final split time is displayed for 10
seconds with the flashing split display indicator, and then the flashing stops.
● The first 100 lap and split times are automatically stored in memory and can be
recalled either during or after the stopwatch measurement.
● Even if the digits are reset to “00” in the stopwatch measurement, the stored data
is not erased and can be recalled unless a new measurement is started.
● In order to recall lap and split times while timing an event, press Button A to cycle
through the 5 different modes. The stopwatch mode indicator (CHR) will continue
to flash to indicate that the STOPWATCH mode is in use.
A
C
D
SPLIT 1
D
SPLIT 2
D
RESET
C
FINAL SPLIT/
STOP
START
“ Lap time” is the time that has
elapsed from the start of one stage
of an activity to that of the next
stage. “Split time” is the time
that has elapsed from the start of
an activity to any given stage.
Start
Lap 1
Lap 2
Split time
Ex.)
Lap No.1: 30 sec. Split No.1: 30 sec.
Lap No.2: 40 sec. Split No.2: 1 min.,10 sec.
Lap No.3: 45 sec. Split No.3: 1 min.,55 sec.