Filter
Top Products
29
English
28
English
■ CARE OF CASE AND BRACELET
To prevent possible rusting of
the case and bracelet, wipe them
periodically with a soft dry cloth.
■ PERIODIC CHECK
It is recommended that the
watch be checked once every 2
to 3 years. Have your watch
checked by an AUTHORIZED
■ SHOCKS & VIBRATION
Be careful not to drop your watch
or hit it against hard surfaces.
■ MAGNETISM
watch away from close contact with magnetic
objects.
The analogue unit of your watch
will be adversely affected by strong
magnetism, though the digital unit
will not be affected. Keep the
■ CHEMICALS
Be careful not to expose the
watch to solvents, mercury,
cosmetic spray, detergents,
adhesives or paints. Otherwise,
the case, bracelet, etc. may become
discolored, deteriorated or damaged.
SEIKO DEALER or SERVICE CENTER to
ensure that the case, buttons, gasket and
crystal seal remain intact.
■ PRECAUTION REGARDING
CASE BACK PROTECTIVE FILM
If your watch has a protective
film and/or a sticker on the case
back, be sure to peel them off
before using your watch.
● Non-water resistant
● Water resistant 5/10/15/20 bar
•If the watch becomes wet, have it
checked by an AUTHORIZED
SEIKO DEALER or SERVICE
CENTER.
• Do not operate the buttons when
the watch is wet or in water.
If used in sea water, rinse the
watch in fresh water and dry it
completely.
• When taking a shower with a
water resistant 5 bar watch, or
taking a bath with a water resistant
10, 15 or 20 bar watch, be sure to
* Pressure in bar is a test pressure and
should not be considered as
corresponding to actual diving depth
since swimming movement tends to
increase the pressure at a given
depth. Care should also be taken on
diving into water.
** We recommend that you wear a
SEIKO Diver’s Watch for scuba
diving.
■ TEMPERATURES
Your watch works with stable
accuracy within a temperature
range of 5°C and 35°C (41°F
and 95°F).
Temperatures over 60°C (140°F) or below
–10°C (+14°F) may cause a slight time loss
or gain or battery leakage or shorten the
battery life.
However, the above conditions will be
corrected when the watch returns to normal
temperature.
observe the following:
* Do not operate the buttons when the watch
is wet with soapy water or shampoo.
* If the watch is left in warm water, a slight
time loss or gain may be caused. This
condition, however, will be corrected when
the watch returns to normal temperature.