Filter
Top Products
57
HOW TO SET THE ALARM HANDS
If the alarm hands do not indicate the current
time of your area when the crown “2” is at
the normal or second click position, the
alarm will not ring properly according to the
time of your area. In that case, follow the
procedure below to set the alarm hands to
the current time.
(1) Pull out crown “1” all the way to the second
click.
Pull out crown “1”
to the second click.
It is recommended that the alarm hand setting
should be made at the same time as you set
the time. Refer to “ TIME SETTING”. This
section only explains the procedure of setting
the alarm hands.
58
(2) Press button A repeatedly to set the alarm
hands to the current time. The hands
move quickly if button A is kept pressed.
Notes:
The alarm hands turn only clockwise.
If the alarm hands turn past the current time,
press the button again to reset the hands to
the correct time.
Then, check and adjust the barometer hand
position. Refer to “ BAROMETER HAND
POSITION ADJUSTMENT”.
Pull out crown “1”
to the second click.
A