Filter
Top Products
www.seuservice.com
26
TURNING POWER ON
During initialization settings, do not touch the ride portion. Wait until the
initialization settings are automatically finished. Touching the ride portion during
setting can cause inaccurate settings and unsatisfactory functioning during game
play.
When the power is turned on, the ride portion moves. To prevent injury, first
check for safety in the periphery of the ride and then turn power on.
If ERROR is displayed in the ADVERTISE mode, do not operate the
machine. Operating the machine when ERROR is displayed can cause
serious hazard.
Turn the AC Unit Main SW ON to turn on the machine's power supply. At the same time the
power is turned on for the power supply, the machine starts the initialization setting movements
and displays the screen on which the setting is being made. Do not touch the Ride until the
initialization setting movements are automatically finished.
After finishing the initialization
setting movements, the ADVERTISE mode returns. During the setting movements, if any
irregularity, malfunctioning, etc. of the moving mechanism are found, ERROR display is shown
on the lower part of the ADVERTISE mode screen. In this case, the machine will not operate
satisfactorily. Please contact the Distributor, etc. where this product was purchased from.
In the case where several machines are connected, network check is performed after
initialization settings are finished, and the screen displays to the effect that the check is being
conducted. After checking, the ADVERTISE mode returns. Normally the network checking
takes 1 ~ 3 minutes. If there is any irregularity in the communication connection, check screen
display will continue.
Approximately 5 seconds after the power is turned on, the compressor starts to operate. If the
pressure inside the tank is insufficient, it takes several minutes to attain the preset pressure. At
the time of installation assembly, it takes approximately 3 minutes. When operation is being
continued, it takes approximately one and half minutes due to the prestress.
The ride portion secures the left/right inclination to the center.
The front of the ride portion
lowers.
The front of the ride portion is
raised.
The front of the ride portion
moves to the intermediate
position in the up/down
movement.
The front of the ride portion
lowers.
The compressor stops.
FIG. 6. 6
1
2
3
4
5
6
7
6