Filter
Top Products
6
.
With the help of a second person, hold the Console Base
(6) and the Right Handrail (32) near the right Upright (14)
as shown. Route the Console Wire Hamess (92) through
the bracket on the Right Handrail.
Refer to the inset drawing. Slide the Strain Relief Clip
(88) onto the Console Wire Harness (92). Make sure that;
there is no slack in the Console Wire Harness between
the Strain Relief Clip and the Console Base (6). Insert a
3/4" ,Screw (91) into the-Strain Re]ief Clil_ _r_d in|o ti_$'i_. ---
dicated hole in the Right.Handrail (32). Tighten the Screw
into the Console Base.
.°
o
With the help of a second person, hold the.Pulse
Handrail (99) near the right Upright (14) as shown. Route
the 30" and 9" Pulse Wii'_s (97, 95) through the bracket
on the Right Handrail (32).
Connect the Console Wire Hamess (92) tothe Upright
Wire Hamess (96). Connect the 30" and 9" Pulse Wires
(97,95) to the Upright Wire Harness (92). Makesure that
the wires with tags are connected to each other. Refer to
the inset drawing if needed.
Insert all wires into the right Upright (14). Insertlhe
bracket on the Right Handrail (32) into theright Upright
(14). Make sure that the wires are not pinched.
5. Attach the Pulse Handra_ (99) to the Left and Right
Handrails (2, 32) with tw.oPulse Handrail Bolts(98) and
Handrail Washers (16).
6. Attach the ConsOle Base (6) to the Left and Right
Handrails (2, 32) with three 3/4" Screws (91).
Bracket_
4
L'-91
__.92_"91
Bracket
99
4"
5
98
=/
32
1 - ll III,°°°
91
6
91