Filter
Top Products
PPt£)R[FM_- ThP_walking belt slows when walked on
SOLUTION: a.
Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge sup-
pressor (TVSS). The surge suppressor must have a UL suppCessed voltage rating of 400 volts or
less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically
rated for 120 volts AC and 15 amps. ...r. ........ _..........
b. if the walking beit is overtightened, treadmill perforo
-_-rnance may decreaseand the .walking belt may be-
pern_anently damaged. Remove the key and UN-
PLUG THE POWER CORD. Using the allen wrench,
turn both rear roller adjustment bolts counterclock-
wise, i/4 of a.tum..When the walking belt is properly
tightened, you should be able to lift each side of the
walking belt 3 to 4 inches offthe walking platform. Be
careful to keep the walking belt centered. Plug in the
power cord, insert the key and run the treadmill for a
few minutes. Repeat until the walking belt is properly
tightened.
c. If the walking belt still Slowswhen walked on, please call our toll-freeHELPLINE.
PROBLEM: The walking belt is off-center when walked on
SOLUTION: a. If the walking belt has shifted to the left, first remove
the key and UNPLUG THE POWERCORD. Using
the allen wrench, turn the left rear roller adjustment
bolt clockwise, and the right boltcountemlockwise,
1/4 of a turn each. Be careful not to overtighten the
walking be_ Plug in the power cord, insert the key
and run the treadmill fora few minutes. Repeat until.
the walking belt is centered.
b. If the walking belt has shifted to the right, first remove
the key and UNPLUG THE POWER CORD. Using
the allen wrench, turn the left rear roller adjustment
bolt counterclockwise, and the rightbolt clockwise,
1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key .
and run the treadmill for a few minutes. Repeat until
the walking beltis centered. -
PROBLEM: The walking belt slips when walked on
SOLUTION: a. If the walking belt slips when walked on, first remove
tl_e key and UNPLUGTHE POWERCORD. Using-
the allen wrench, turn both rear roller adjustment
bolts clockwise, 1/4 of a turn. When the walking belt
is correctly tightened, you should be able to lifteach
side of the walking belt 3 to 4 inchesoff the walking
platform. Becareful to keep the walking belt centered
Plug in the power cord, insert the key and run-the
treat:lmillfor a few minutes. Repeat untilthe walking
belt is properly tightened.
a
15