Filter
Top Products
MAINTENANCE AND TROUBLE-SHOOTING
Most treadmill problems can be solved by following the simple steps below. If further assistance is
needed, call our toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7 a'.m. until 7 p.m.
Central Time (excluding holidays),
PROBLEM: The power does not turn on
SOLUT.10N: a.
Make sure that the power cord is plugged !nto a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (_seepage 8). Use onlya single-outletsurge suppressor
that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The surge suppressor
must have a UL suppressed voltage rating of 400 volts or less and a minimumsurge dissipation
of 450 joules. The surge suppressor must be electdcally rated for 120 voltsAC and 15 amps.
b. After the power cord has been plugged in, make sure that the key is fully insertedinto the con-
sole. (See step 1 on page 9.)
c. Check the circuit breaker located on the treadmill
near the power cord. If the switch protrudes as
shown, the circuitbreaker has tripped;.To reset the
circuit breaker, wait for five minutes and then press
the switch back in.
d. Check the on/off sw_ch located on the treadmill
near the power cord. The switch must be in the "on"
position.
•PROBLEM: The power turns off during use
Reset
d
Position
SOLUTION: a. Check the circuitbreaker located on the treadmill frame near the power cord (see 1. c. above). If
the circuitbreaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord isplugged in.
c. Remove the key from the console. Reinsert the key fully into the console. (See step 1 on page 9.)
d. Make sure that the on/off switch is in the =on" position. (See 1. d. above.)
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the six screws from the hood. Carefully re-
move the hood. Locate the Reed Switch (86) and the
Magnet (87) on the left side of the Pulley (85). Turn
the Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch isabout 118". If nec,
essary, loosen the Screw-(35) and move theReed
Switch slightly. Retighten the Screw. Re-attach the
hood, and run the treadmill for a few minutes to check
for a correct speed reading.
Top
wow Ii I!
14