Filter
Top Products
ASSEMBLY
..•
Assembly requires two people. Set the treadmill in a cleared area and remc>veall packing materials. Do not
dispose of the packing materials until assembly is completed. Refer to the drawings below .t.oidentify the small
the included• allen wrench¢h_ and your own i_hillips screw-
parts used in assembly. Assembly requires , and scissors _.
driver ,,==_=E:_), adjustable wrench _ _.. ._ .
Handrail Washer (16)-4
1/2" Screw (13)-2. -
.... "Extension Leg Screw (34)-2
n© @"
_\ Handrai! B°RL._(15 3/4" Screw (91)-4
h
Flange Nut (57)-2
3/8" Washer (61)-2
3 1/2" Handrail Bolt (89)-2
. W'dhthe help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
1
..°
o
Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 13. Follow the instructions to lower the treadmill.
Position the Left Handrail (2) on the left Upright (14). The
lower end of the Left Handrail should be on the Outside of
the Extension Leg (41) as shown. Thread a Handrail Bolt
(15) with a HandrailWasher (16) into the left Upright and
the Left Handrail. Do not.tighten the Handrail Bolt yet.
Attach the lower endof the Left Handrail (2) to the
Extension Leg (41) with a 3 1/2"Handrail Bolt (89), a 3/8"
Washer (61), and a.Flange Nut (57). Do not tighten the
Handrai!_.Bolt yeL
2
5