Filter
Top Products
c. Error code "E4" may appear in the SPEED display if the walking belt is moving at a slow speed, and there is "
excessive stress on the motor. Remove the key, wait for ten seconds, and then reinsert it. If youweigh over
200 pounds, itmay be helpfulto increase the incline of the treadmill. Ifthe error code appears again, call our
toll-free Customer Service Department. Do not operate the treadmill until the problem is corrected.
d. Error code "E5" may appear in the PULSE displayif a pulse error occurs. See HOW TO USE THE PULSE
SENSOR on page 8, and PULSE DISPLAY on page 12.
5. SYMPTOM: THE PULSE SENSOR DOES NOT FUNCTION PROPERLY
a. See HOW TO USE THE PULSE SENSOR on page 8, and PULSE DISPLAY on page 12.
6. SYMPTOM: THE WALKING BELT IS OFF-CENTER WHEN WALKED ON
a. If the walking belt has shifted to the left, first remove the key and
UNPLUG THE POWER CORD. Using the allen wrench, turn the
left rear roller adjustment bolt clockwise 114of a turn. Plug in the
power cord, insert the key and run the treadmill for a few min-
utes. Repeat untilthe walking belt is centered.
a
b. If the walking belt has shifted to the dght, first remove the key
and UNPLUG THE POWER CORD. Using the allen wrench,
turnthe left rear roller adjustment bolt counterclockwise 1/4 of a
turn. Plug in the power cord, insert the key and runthe treadmill
for a few minutes. Repeat untilthe walking belt is centered.
b
7. SYMPTOM: THE TREADMILL SITS UNEVENLY ON THE FLOOR
a. Make sure that the six base pads are attached tothe treadmill. See assembly step 2 on page 6.
21