Filter
Top Products
TROUBI E:SHOOTING " " '
2O
Most treadmill problems r.an be solved by following the Simple Steps below. Rnd the sym'p|omthat ap-- ....
plies, and follow the steps listed.
If further assistance Is needed, call bur toll-free HELPLINE at 1-800-736-6879, Monday through Saturday, 7
a.m. until 7 p.m. Central Time (excluding holidays).
1. SYMPTOM: THE POWER DOES NOT TURN ON
a. Make sure that the power cord is plugged into a surge protector, and that the surge protector is plugged into
a propedy grounded outlet. (See HOW TO PLUG IN THE POWER CORD on page 9.) Use only a UL-listed
surge protector, rated at 15 amps, with a 14-gauge cord offive feet or less in length.
b. After the power cord has been plugged in, make sure that the key isfully inseded intothe console. Various
indicators on the console should light.(See step 1 page 11.)
c. Check the circuitbreaker located on the treadmill near the
power cord. If the switchprotrudes as shown, the circuit
breaker has tripped. To reset the circuit breaker, wait for five
minutes and then press the switch back in.
d. Check the on/off switchlocated at the front of the treadmill
near the power cord. The switch must be in the =on"position.
2. SYMPTOM: THE POWER TURNS OFF DURING USE
Tdpped
"On" "_
Position
a. Check the cimuifbreaker located on the treadmill near the power cord (see 1. c. above). If the circuit breaker
has tripped, wait for five minutesand then press the switch back in.
b. Make sure that the power cord is plugged in.
c. Remove the key from the console, and reinsed itfully into the console. (See step I on page 11.)
d. Check to make sure that the on/off switch is in the =on" position. (See 1. d. above.)
e. If the treadmill stillwill not run, please call our toll-free HELPLINE.
3. SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON
a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord offntefeet or less In length.
b. If the walking belt stillslowswhen walked on, please call our tolHree HELPLINE.
4. SYMPTOM: AN ERROR CODE ("El," "E2," "E3," "E4," OR "ES") APPEARS ON THE CONSOLE
a. If error code "El" appears in the DISTANCE/INCLINE display, a malfunction may have occurred in the in-
cline system. Remove the key, wait for ten seconds, and then reinsed it. If the error cede appears again, call
our toll-free HELPLINE. Do not operate the treadmilluntilthe problem is corrected.
b. Error code "E2" may appear in the SPEED display ifthe SPEED increase or START/PAUSE button is
pressed and no movement of the walking belt isdetected within seven seconds. Remove the key, wait for
ten seconds, and then reinsert it. Make sure that you stand on the foot roilsof the treadmill each timeyou
stad the walking belt. If the error code appears again, call our toll-free HELPUNE. Do not operate the tread-
mill until the problem iscorrected.