Filter
Top Products
ASSEMBLY
Before beginning assembly, carefully read the
following Information and instructions:
• Place all parts in a cleared area and remove the
packing materials; do not dispose of the packing
materials until assembly is completed.
• Read each assembly step before you begin.
• Be sure that all pads are oriented as shown in
the drawings.
• "nghten all parts as you assemble them, unless
instructedto do otherwise.
THE FOLLOWING TOOLS ARE REQUIRED FOR
ASSEMBLY:
• The included pedal tool
• Your own phillips screwdriver
• Your own rubber mallet
• A small amount of lubricant, such as grease
or petroleum jelly.
4
Note: Before you attach the 1/2" Dome Caps
(29) in assembly steps I and 2, be sure that all
parts are in the correct positions. The Dome
Caps can be used only once; if a part is incor-
rectly assembled, it will be necessary to
remove the Dome Caps and order new ones.
Be sure that there is a 1/2" Pivot Bushing (25) in
each side of the Frame (6).
Lubricate the Pedal Frame Axle (21). Align the
indicated holes in the Pedal Frame (7) with the
1/2" Pivot Bushings (25) in the Frame (6). Insert
the Pedal Frame Axle through the Pedal Frame
and the Frame. Center the Pedal Frame Axle and
tap a t/2" Dome Cap (29) onto each end of it.
29 Holes
21 -Lubricate
29
2. See the inset drawing. Make sure that there is a
1/2" LinkArm Bushing (26) in the left Link Arm
(4).
Slide the end ofthe left Unk Arm(4) onto the indi-
cated pin on the Pedal Frame (7). Pivot the Pedal
Frame and tap a 1/2" Dome Cap (29) onto the
pin.
Attach the dght Link Arm (4) to the Pedal Frame
(7) in the same manner.
2
5_