Filter
Top Products
IdentifytheFrontStabilizer(3),Whileanotherperson
liftsthefrontoftheFrame(1),attachtheFront
Stabilizerto theFramewithtwoMIOx 112mm
CarnageBolts(34)andtwoMIONylonLocknuts(29),
MakesurethattheFrontStabilizeris turnedsothe
Wheels(32) are not touching the floor.
While another person lifts the back of the Frame (1),
attach the Rear Stabilizer (4) to the Frame with two
MIO x 112mm Carnage Bolts (34) and two MIO Nylon
Locknuts (29),
While another person holds the Upnght (2) in the posi-
tion shown, connect the Upper Wire Harness (86) to
the Lower Wire Harness (87), Carefully pull the
upper end of the Upper Wire Harness to remove
any sJack. While hoJding the upper end of the
Upper Wire Harness, insert the Upnght into the
Frame (1), Do not pinch the Wire Harnesses.
Slide an MIO Split Washer (70) and a Frame Spacer
(83) onto an MIO x 88mm Button Screw (63), Insert
the Button Bolt into the Frame (1) and the Upright (2),
Make sure that the concave end of the Frame
Spacer is turned toward the Frame. Do not tighten
the Button Bolt yet.
Attach the Water Bottle Holder (91) to the Upright
(2) with two M4 x 22mm Screws (93).
While another person holds the Console (5) in the
position shown, connect the wire harness on the
Console to the Upper Wire Harness (86), Insert the
excess wire harness into the Upright (2), Next, attach
the Console to the Upright with four M4 x 16mm
Screws (66), Be careful to avoid pinching the wire
harnesses.
2
/
29
\
29
4
/
91
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
793
/,
86
/
1
83
4
Wire
Harness
86
66
66
/ /,
"i '/
Make sure the
wire harnesses
do not get
pinched and
damaged during
this step.
6