Filter
Top Products
22
61. Attach the Lock Plate (21) to the Right Seat
Frame (3) with an M8 x 68mm Shoulder Bolt (41),
an M8 W
asher (98), and an M8 Nylon Locknut
(91).
Do not overtighten the Locknut; the Lock
Plate must be able to pivot easily
.
Attach the Leg Pin (24) to the Right Seat Frame
(3) with an M4 x 16mm Self-tapping Screw (89).
Insert the Leg Pin through the Leg Lever (4) and
the Lock Plate (21).
63. Slide two Leg Lever Foam Pads (35) onto the
Leg Lever (4).
62. Slide the Pad Tube (16) through the Right Seat
Frame (3). Slide two Small Foam Pads (18) onto
the Pad Tube. Press two Foam Caps (17) into the
Pad Tubes.
61
62
91
98
3
4
89
24
21
41
3
16
18
17
18
17
63
35
35
4
64. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If
the cables are not properly installed, they may be damaged when heavy weight is used. See the
CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack
in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on
page 28.