Filter
Top Products
16
LUBRICATING THE WALKING BELT
The Walkmill™ requires little maintenance other then periodically
applying lubricant. Lubricating under the Walking Belt will ensure
superior performance and extend the working life of the Walkmill.™
To check for proper lubrication, lift one side of the Walking Belt and feel
the top of surface of the Walking Deck. If the surface is slick to the
touch, then no further lubrication is necessary. If the surface is dry to
the touch, apply a half of a bottle of the lubricant that is included with
your Walkmill.™
To apply lubricant, lift one side
of the Walking Belt and pour
1/2 the bottle of lubricant under
the center of the Walking Belt
on the top surface of the
Walking Deck.Then walk on the
Walkmill™ at a slow speed for
3 to 5 minutes to evenly
distribute the lubricant.
NOTE: Do not over
lubricate the Walking
Deck. Be sure to wipe
off any excess lubricant
that comes out from
under the Walking Belt.
Be careful not to spill
lubricant on your floor
or carpet.
3
GROUNDING INSTRUCTIONS
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for the current, and will
reduce the risk of electrical shock.The plug must be plugged into an
appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DANGER! Improper connection of the equipment-grounding
conductor can result in a risk of electric shock. Check with a qualified
electrician or serviceman if you are in doubt as to whether the product
is properly grounded. Do not modify the Plug provided with the product
— if it will not fit the outlet, have a proper outlet installed by a
qualified electrician.
This product is for use on a normal 120-volt
circuit and has a grounding plug that looks like
the plug illustrated in the Figure A. However, a
temporary adapter that looks like the adapter
illustrated in Figures B and C may be used to
connect this plug to a 2-pole receptacle as
shown in Figure B if a properly grounded outlet
is not available.The temporary adapter should
be used only until a properly grounded outlet
(Figure A) can be installed by a qualified
electrician.The green colored rigid ear, lug or
the like extending from the adapter must be
connected to a permanent ground such as a
properly grounded outlet box cover. Whenever
the adapter is used, it must be held in place by
a metal screw.
Grounding
Pin
Grounded
Outlet
Metal
Screw
Figure A Figure B
Figure C
Adapter
Adapter
For Grounding
Screw