Filter
Top Products
25
Troubleshooting
Question: I have taken photos, but my computer says "No photos in camera."
What do I do?
Answer: First, ensure that you have taken photos with your camera. Press
the shutter button a few times to take some sample photos and try again.
If you still get a no photos error, this indicates that the software was not
installed correctly or you may not meet the minimum system requirements.
At least a Pentium II 300 MHz, AMD Athlon 300 MHz, or a Celeron 400 MHz or
higher, at least 64 MB of RAM. Please note that the older AMD K6 processors
will not work. If you have determined that you have pictures in your camera
and you meet the system requirements, follow the steps below to reinstall
the software.
Software Re-installation:
1. First install the software. Click on Start, Settings, Control Panel
and Add/Remove programs. You will need to remove Spy Shot Photo
Manager. After removing it, restart your computer. If your camera is
connected, disconnect it.
2. Now reinstall the software. Insert the CD that came with your
camera. It should automatically run the installation.
3. Restart the computer.
4. Once your computer is back up, plug the camera into your
computer's USB port.
5. Right-click on the "My Computer" icon. Select Properties. Click on