Filter
Top Products
7
100
122
132
48
6. Identify the Left Pedal (48), which is marked with an
“L.” Attach the Left Pedal to the Left Pedal Leg (46)
with two M8 x 52mm Button Bolts (100), two M8 Split
Washers (122), and two M8 Washers (132).
Attach the Right Pedal (not shown) to the Right
Pedal Leg (not shown) in the same way.
5. Hold a Ramp Wheel (50) inside of the bracket on one
of the Chrome Tubes (45). Hold the Chrome Tube and
the Ramp Wheel inside of the bracket on the Left
Pedal Leg (46). Slide a Wheel Cover (51) onto the
long part of a Bolt Set (101), and insert the Bolt Set
into the Left Pedal Leg, the Chrome Tube, and the
Ramp Wheel.
Slide a Wheel Cover (51) onto the short part of the
Bolt Set (101). Then, tighten the short part of the Bolt
Set into the long part.
Attach the other Chrome Tube (not shown) and the
other Ramp Wheel (not shown) to the right side of
the elliptical exerciser in the same way.
6
7
118
2
18
123
53
1
7. Have another person hold the Upright (2) in the posi-
tion shown. Make sure that the Upright is turned so
that the three holes are aligned with the holes in
the Frame (1).
Connect the Upper Wire Harness (18) to the Lower
Wire Harness (53). Carefully pull the upper end of
the Upper Wire Harness to remove the slack from
the Wire Harnesses. Slide the Upright (2) onto the
Frame (1). Be careful to avoid pinching the W
ire
Harnesses. Attach the Upright to the Frame with three
M10 x 25mm Button Screws (123) and three M10 Split
Washers (118).
50
45
101
101
51
46
5
51
46
132
122
123
1
18
118