Filter
Top Products
7
3. Attach the Track Frame (4) to the Frame (1) with
two M10 x 123mm Button Screws (87) and two
M10 Split Washers (85). Finger tighten a Button
Screw into the lower hole first, and then finger
tighten a Button Screw into the upper hole. Then,
tighten both Button Screws. Note: This step may
be easier if you raise the Frame a few inches in the
location shown by the arrow at the right while you
attach the Track Frame.
85
4
1
87
85
87
3
4. Apply a small amount of the included grease to the
sides of two Wave Washers (88) and two Thrust
Washers (66).
Slide a Weld Spacer (89) onto the Left Crank Arm
(83). Next, identify the Left Track Arm (12), which
is marked with an “L.” Orient the Left Track Arm as
shown, and slide it onto the Left Crank Arm. Then,
slide a Wave Washer (88) on the end of the Left
Crank Arm.
Slide an M8 Small Washer (18) and an Axle Cap
(41) onto an M8 x 19mm Button Screw (56). Next,
slide a Thrust Washer (66) onto the shoulder of
the Axle Cap. Then, tighten the Button Screw into
the end of the Left Crank Arm (83). Make sure
that the Thrust Washer remains on the shoul-
der of the Axle Cap, and that the Wave Washer
(88) remains on the end of the Left Crank Arm.
Repeat this step to attach the Right Track Arm
(11) to the right side of the elliptical exerciser.
11
83
89
88
41
56
12
18
66
4
Grease