Filter
Top Products
8
4. With the help of a second person, hold the con-
sole assembly near the Uprights (73, 74).
C
onnect the Upright Wire (75) to the Console
Wire Harness (71). See the inset drawing. The
c
onnectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
Remove the wire tie from the Upright Wire (75).
71
Console
Assembly
4
75
Wire
Tie
74
5. Insert the brackets on the Handrails (99) into the
Uprights (73, 74). Make sure that no wires are
pinched.
73
5
74
99
6. Partially tighten six 3/8" x 1 1/2" Bolts (64) with
six 3/8" Star Washers (90) (only three are
shown) into the Uprights (73, 74). Then, firmly
tighten all six Bolts.
73
74
64
64
90
90
75
6
73
99
71