Filter
Top Products
15
Regardless
of which
display
m
ode you
select, the
s
peed or
incline set-
ting will appear in the display for a few seconds
each time you change the setting. In addition, your
heart rate will appear in the display each time you
use the handgrip pulse sensor or put on the chest
pulse sensor. Note: If you select the display mode
shown above, your heart rate will be shown in place
of the approximate exercise pace.
As you exercise, the intensity level bar will indicate
the approximate intensity level of your exercise. For
example, if eight of the indicators in the bar are lit,
the bar shows that your intensity level is ideal for
aerobic exercise.
To reset the console, press the Stop button, re-
move the key, and then reinsert the key.
7. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the chest pulse sensor at the same time, the
console will not display your heart rate accu-
rately.
Before using the handgrip pulse sensor, remove
the sheets of clear plastic from the metal contacts.
In addition, make sure that your hands are clean.
To measure
your heart
rate, stand on
t
he foot rails
and hold the
m
etal contacts
on the
handrail—
avoid moving
your hands.
When your pulse is detected, your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
8. Turn on the fan if desired.
The fan has high and low speed settings. Press the
Fan button repeatedly to select a fan speed or to
turn off the fan. Note: If the fan is on when the
walking belt stops, the fan will automatically turn off
after a few minutes.
9. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when you fold the treadmill to the storage posi-
tion, or you may damage the treadmill. Next, re-
move the key from the console and put it in a secure
place.
When you are finished using the treadmill, switch
the reset/off circuit breaker to the “off” position and
unplug the power cord. IMPORTANT: If you do
not do this, the treadmillʼs electrical compo-
nents may wear prematurely.
Intensity Level Bar
C
ontacts