Filter
Top Products
7
2. Identify the Left Upright (73) and the Right
Upright (74). See the inset drawing. Tie the wire
tie in the Right Upright (74) securely around the
e
nd of the Upright Wire (75). With the help of a
second person, hold the Right Upright near the
R
ight Base Cover (77). Then, pull the other end
of the wire tie up through the rectangular hole in
the bottom of the Right Upright until the Upright
Wire is routed completely through the Right
Upright.
Gently pull up on the Upright Wire (75) as you
set the Right Upright (74) on the Base (83) in-
side the Right Base Cover (77). Be careful not
to pinch the Upright Wire.
Attach the Right Upright (74) to the Base (83)
with two 3/8" x 3 3/4" Bolts (72) and two 3/8"
Star Washers (90). Do not tighten the Bolts
yet. Note: It may be necessary to tip the top of
the Right Upright forward slightly and rotate the
bottom as you thread the Patch Bolts into the
Right Upright.
Attach the Left Upright (73) to the Base (83)
in the same way. Note: There are no wires on
the left side.
With the help of a second person, lower the
treadmill off the cardboard stand. Save the card-
board stand for step 8.
83
75
W
ire
Tie
77
2
74
73
90
72
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95); the Sleeves are la-
beled “Right” and “Left.” Slide the Right Upright
Sleeve onto the Right Upright (74) and the Left
Upright Sleeve onto the Left Upright (73).
95
“Right”
“Left”
96
3
74
73
75
74
Wire Tie