Filter
Top Products
5
M8 Nylon
Locknut (37)–4
M8 Split
Washer (36)–4
M10 Black Split
Washer (34)–4
M10 x 73mm Button Bolt (33)–6
M10 x 20mm Button
Screw (35)–3
M6 Nylon
Locknut (54)–4
M10 Nylon
Locknut (52)–2
M4 x 15mm
Screw (40)–4
M4 x 25mm
Screw (39)–6
M4 x 15mm
Screw (15)–2
M6 x 40mm Button
Bolt (53)–4
M10 Bright Split
Washer (55)–3
1. Identify the Front Stabilizer (2), which is narrow-
er than the Rear Stabilizer (not shown). While
another person lifts the front of the Frame (1),
attach the Front Stabilizer to the Frame with two
M10 x 73mm Button Bolts (33) and two M10
Black Split Washers (34).
2
33
34
1
1
ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the includ-
ed tools and your own adjustable wrench and Phillips screwdriver .
Use the part drawings below to identify the small parts used in assembly. The number in parentheses below
each drawing refers to the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been preassembled.