Filter
Top Products
9
9.
Attach a Pulley Bracket (17) to the indicated “U”-
channel (18) with an M10 x 132mm Button Bolt
(69), two M10 W
ashers (59), and an M10 Nylon
Locknut (56).
W
rap the Long Cable (42) over a 90mm Pulley
(38). Attach the Pulley inside the Pulley Bracket
(17) with an M10 x 41mm Button Bolt (71) and an
M10 Nylon Locknut (56).
8. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Guards (37) to the Base (2) with an M10 x
52mm Patch Screw (80) and an M10 Washer
(59).
Make sure that the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
7a
7b
8
41
59
38
37
39
69
42
69
37
38
42
37
39
38
59
37
80
2
56
56
69
59
71
42
18
59
17
38
9
7. Note: This step may be easier if the resistance
system is tipped over forward (see drawing
7
b).
R
oute the Long Cable (42) around a 90mm Pulley
(38). Insert an M10 x 132mm Button Bolt (69) into
a Guard (37), a Cable Trap (39), the Pulley, an
M10 Washer (59), an 8mm Spacer (41), another
Guard (37), and another 8mm Spacer (41).
Note:
The end of the Button Bolt must be flush with
the edge of the last Spacer. Make sure that the
Cable Trap is oriented to hold the Cable in the
groove of the Pulley.
See drawing 7b
. Insert the 90mm Pulley (38) into
the Rear Frame (10). Push the M10 x 132mm
Button Bolt (69) through the Rear Frame and the
Left Upright (6). Finger tighten an M10 Nylon
Locknut (56) onto the Button Bolt. Do not tighten
the Nylon Locknut yet.
56
6
10