Filter
Top Products
10
11. Route the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Guards (37) to the indicated hole in the Base
(2) (see the inset drawing) with an M10 x 52mm
Patch Screw (80) and an M10 Washer (59).
Make
sure that the Cable Trap is oriented to hold
the Cable in the groove of the Pulley.
12. Attach a Pulley Bracket (17) to the indicated “U”-
channel (18) with an M10 x 132mm Button Bolt
(69), two M10 Washers (59), and an M10 Nylon
Locknut (56).
Wrap the Long Cable (42) over a 90mm Pulley
(38). Attach the Pulley inside the Pulley Bracket
(17) with an M10 x 41mm Button Bolt (71) and an
M10 Nylon Locknut (56).
13. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
two Guards (37) to the Base (2) with an M10 x
52mm Patch Screw (80) and an M10 W
asher
(59).
Make sure that the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
Note: The Guards (37) attached in this step
will overlap the Guards attached in steps 8
and 11.
11
12
13
56
56
69
59
71
42
18
59
17
38
42
37
39
Hole
38
59
37
80
2
2
42
37
39
38
59
37
80
2
10. Wrap the Long Cable (42) under a 90mm Pulley
(38). Attach the Pulley, a Cable Trap (39), and
t
wo Guards (37) to the Base (2) with an M10 x
52mm Patch Screw (80) and an M10 Washer
(
59). M
ake sure that the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
Note: The Guards (37) attached in this step
will overlap the Guards attached in step 8.
1
0
42
37
39
38
59
37
8
0
2