Filter
Top Products
20
Inspect and properly tighten all parts of the exercise
cycle regularly. The exercise cycle can be cleaned
w
ith a soft, damp cloth. To prevent damage to the
console, keep liquids away from the console and keep
t
he console out of direct sunlight.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
CONSOLE TROUBLESHOOTING
If the console display becomes dim, the batteries
should be replaced. See assembly step 5 on page 6
for replacement instructions. If the console does not
display your heart rate when you use the handgrip
pulse sensor
, see step 5 on page 13.
HOW TO LEVEL THE EXERCISE CYCLE
If the exercise
cycle rocks slight-
ly on your floor,
turn one or both
of the leveling
pads until the
exercise cycle is
level.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is at the highest level, the
Belt (not shown) may need to be adjusted. To adjust
the Belt, the Right Side Shield (5) must first be
removed. Remove the indicated M4 x 38mm Screws
(30) and M4 x 16mm Screws (21) from the Right Side
Shield. Using an adjustable wrench, turn the Right
Pedal (37) counterclockwise and remove it. Next, turn
t
he Crank (33) so that it points toward the front of the
exercise cycle, and then slide off the Right Side
S
hield.
Next, turn the
indicated M8 x
40mm Screw
(58) until the
Belt (69) is
properly tight-
ened. Then,
reattach the
right side
shield and the
right pedal.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. See HOW TO
ADJUST THE BELT at the left. Remove the indicated
M4 x 38mm Screws (30) from the Right Side Shield
(5) and the M4 x 16mm Screws (not shown) from the
Left Side Shield (4). Using an adjustable wrench, turn
the Left Pedal (not shown) clockwise and remove it.
Turn the Crank (33) so that it points toward the front
of the exercise cycle, and then slide off the Left Side
Shield.
Locate the
Reed Switch
(44).
Turn the
Crank (33)
until the
Magnet (18) is
aligned with
the Reed
Switch.
Loosen, but
do not
remove, the
indicated M4 x
16mm Screw
(21). Slide the
Reed Switch slightly closer to or away from the
Magnet. Then, retighten the Screw. Turn the Crank for
a moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the left side shield and the left pedal.
Leveling
Pads
30
21
5
4
37
58
33
69
33
21
44
18
MAINTENANCE AND TROUBLESHOOTING