Filter
Top Products
9
11. Route the Press Arm Cable (66) over a 3 1/2"
Pulley (43). Attach the Pulley and a Cable Trap
(
47) to the Top Frame (12) with an M10 x 40mm
Screw (97).
Make sure that the Cable Trap is
o
riented to hold the Cable in the groove of the
Pulley.
13. Use the wire in the Right Press Arm (8) to pull the
Press Arm Cable (66) down through the Press
Arm. Make sure that the Cable is routed
around the pulleys above the Press Arm as
shown in the inset drawing.
Hold a 4" Pulley (42) over the Press Arm Cable
(66). Attach the Pulley inside the Swivel Arm (26)
with an M10 x 50mm Button Bolt (88), two M10
Washers (105), two 16mm x 6mm Spacers (11),
and an M10 Nylon Locknut (108).
14. Orient the Cable Cover (63) as shown and slide it
onto the Press
Arm Cable (66).
Insert the Press Arm Cable (66) into the Cable
Coupler (64).
Tighten four M6 x 10mm Set
Screws (1
14) into the Cable Coupler to hold the
Cable in place.
Slide the Cable Cover (63) over the Cable
Coupler (64).
12. Route the Press Arm Cable (66) through the Top
Cover (24) and over a 3 1/2" Pulley (43). Attach
the Pulley and a Cable Trap (47) to the Top
Frame (12) with an M10 x 40mm Screw (97).
Make sure that the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
12
6
6
43
11
12
47
97
12
43
24
47
97
66
88
105
13
14
105
108
66
63
64
1
14
1
14
66
8
42
11
11
26
66