Filter
Top Products
16
28
27
48
66
48
43
47
16
96
108
76
Lever
MOVING THE WEIGHT SYSTEM
T
o move the weight system, step on the levers on the
Locking Casters (76) to unlock the wheels. Move the
w
eight system to the new location. Relock the wheels
on the Locking Casters.
CHANGING THE WEIGHT SETTING
To change the setting of the weight stack, insert the
Weight Pin (28) under the desired Weight (27). Insert
the Weight Pin so that the bent end touches the
weight stack. Turn the bent end down.
Note: Due to the cables and pulleys, the amount
of resistance at each exercise station may vary
from the weight setting. Use the WEIGHT
RESISTANCE CHART on page 17 to find the
approximate amount of resistance.
ADJUSTING THE CABLE
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cable before resistance is felt, the
cables should be tightened.
To tighten the Press Arm Cable (66), remove the M10
x 50mm Bolt (96) from the W
eight Tube (16).
Reattach the 3 1/2" Pulley (43), the Cable Trap (47),
and the two Finger Guards (48) to a lower hole in the
Weight Tube with the Bolt and an M10 Nylon Locknut
(108). Make sure that the Cable Trap is oriented to
hold the Press Arm Cable (66) in the groove of the
Pulley. To loosen the Cable, attach the Pulley to a
higher hole in the Weight Tube.