Filter
Top Products
11
18. Attach the Bumper (36) to the Leg Developer (6)
with an M4 x 19mm Self-tapping Screw (100).
Apply grease to the barrel of a 2.5" Bolt Set (86).
Attach the Leg Lever (6) to the Seat Frame (4)
with the Bolt Set.
Make sure that the barrel of
the Bolt Set is inserted through both sides of
the bracket on the Front Leg. Do not over-
tighten the Bolt Set; the Leg Lever must pivot
easily.
17. Attach the Seat (19) to the Seat Frame (4) with
two M6 x 30mm Screws (87) and an M6 x
1
00mm Screw (85).
S
et the Seat Frame (4) onto a set of posts on the
Upright (3).
17
19
4
3
85
87
18
86
Grease
Bracket
4
86
100
36
6
33
10
34
35
51
102
102
5
19. Attach a Front and Rear Dip Cap (33, 34) around
a Dip Handle (10) with two M3 x 32mm Self-tap-
ping Screws (102).
Tighten a Dip Arm Knob (51) into the Dip Arm (5).
Pull the Knob out as far as it will go and insert the
Dip Handle (10) through a Dip Arm Bushing (35)
and into the Dip Arm. Engage the Knob into the
Dip Handle.
Repeat this step on the other side of the Dip
Arm (5).
19
20. Attach an Arm Pad (21) and an
Arm Pad Base
(22) to the Dip
Arm (5) with two M6 x 70mm
Screws (93).
Repeat this step on the other side of the Dip
Arm (5).
20
21
22
93
5