Filter
Top Products
12
22. Attach the Curl Pad (20) to the Curl Post (9) with
two M6 x 30mm Screws (87).
23. Make sure that all parts are properly tightened
before using the weight system. The use of the
remaining parts will be explained in the ADJUST-
MENTS section, beginning on the following page.
21. Insert a Pad Tube (17) into the Leg Developer
(6). Next, slide two Leg Pads (23) onto the Pad
T
ube. Then, slide two Pad Covers (30) onto the
Leg Pads, and press a 19mm Large Round Cap
(
118) into each Pad Cover.
Repeat this step for the Seat Frame (4).
2
1
6
4
17
23
30
118
20
9
87
22
23
30
118