Filter
Top Products
15
The left side of the dis-
play will show the incline
l
evel of the treadmill, the
elapsed time, and the
d
istance you have
walked or run. Note:
When a program is selected, the display will show
the time remaining in the program instead of the
elapsed time.
The right side of the
display will show the
speed of the walking
belt, the approximate
number of calories you
have burned, and your
pace (in minutes per mile). The display will also
show your heart rate when you use the handgrip
pulse sensor or the optional chest pulse sensor.
To reset the display, press the Stop button, re-
move the key, and then reinsert the key.
Note: The console can
display speed and dis-
tance in either miles or
kilometers. To determine
which unit of measure-
ment is selected, hold
down the Stop button while inserting the key into
the console. An “E” for English miles or an “M” for
metric kilometers will appear in the right side of the
display. Press the Quick Speed increase button to
change the unit of measurement. When the de-
sired unit of measurement is selected, remove the
key.
Note: For simplicity, all instructions in this
section refer to miles.
Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
the optional chest pulse sensor at the same time,
the console will not display your heart rate accu
-
rately. Before using the handgrip pulse sensor, re
-
move the clear plastic film from the metal con-
tacts. In addition, make sure that your hands are
clean.
To measure
your heart
r
ate,
s
tand
on the foot
r
ails
a
nd
hold the
metal con-
tacts on the
handrail—
avoid moving your hands. When your pulse is
detected, the heart symbol in the right side of the
display will appear, one or two dashes will appear,
and then your heart rate will be shown.
For the
most accurate heart rate reading, continue to
hold the contacts for about 15 seconds.
Turn on the fan if desired.
To turn on the fan at low speed, press the Cool
Breeze Fan button. To turn on the fan at medium
speed, press the button a second time.To turn on
the fan at high speed, press the button a third
time. To turn off the fan, press the button again.
Note: If the fan is left on when the walking belt is
stopped, the fan will automatically turn off after a
few minutes.
When you are finished exercising, remove the
key.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will be damaged. Next, re-
move the key from the console and put it in a se-
cure place. Note: If the display remains lit after
the key is removed, the console is in the
“demo” mode. See page 19 and turn off the
demo mode.
When you are finished using the treadmill,
switch the reset/off circuit breaker to the off
position and unplug the power cord.
8
7
6
Contacts